I have set up several configurations for a TC-08 data logger but cannot seem to find a way to select a particular setup. I also can't seem to find a way of erasing a current device config and starting again.
Is there any way to select a particular, previously saved, configuration?
Hopefully I'm just missing something obvious!
Regards,
John
Picolog 6 configurations
Re: Picolog 6 configurations
Hi John
In PicoLog 6 you should be able to load the configuration files that you save by going to the Files tab and opening the appropriate configuation
Neil
In PicoLog 6 you should be able to load the configuration files that you save by going to the Files tab and opening the appropriate configuation
Neil
Neil
Technical Support Engineer
Technical Support Engineer