I have a Picoscope 2408b. I have downloaded the LabVIEW driver and I am trying to work with it. I first tried to work with Picoscope 6 to understand it and I was able to get it working, I tried on Picoscope 6, sine wave and square wave with 2V and 1kHZ with no trigger and it worked perfectly. Then I moved on to the labview and I opened up the Picoscope 2000aExampleAWG. I tried the same thing. For General AWG settings I gave sine, no offset, no trigger, Voltage as 1000000 and then I give start frequency of 1000 and stop also 1000. And then when I run the program, nothing happens, there is no error, the software is detecting the picoscope, so no error. But when I run the labview 2000aexampleAWG program nothing happens, also but in the picoscope itself the red light goes off. I tried it in highlight execution mode and thats when I found out that the red light goes off as soon PS2000a Open is finished running. So I am not sure how does this work. Kindly do help me. Thank you.
Forum for discussing PicoScope version 6 (non-automotive version)
1 post • Page 1 of 1