TC-08, Labview 2017 and WIN10/64

Post your LabVIEW discussions here
Post Reply
Posts: 0
Joined: Sun Feb 02, 2020 7:18 pm

TC-08, Labview 2017 and WIN10/64

Post by skulkerfox »


I am using a TC-08 with LabVIEW 2017 in WIN10/64 for a lab experiment reading type N T/C's and mV level signals. The latest PicoLog software and SDK-64 are installed on the system. When the same program/configuration was run in WIN7 on a Q9400 based computer, there were no issues. The computer was replaced as a result of WIN7 EOL.

Now every so often in LabVIEW, the error message that the TC-08 has lost communications and has to be disconnected/reconnected/system reboot to operate is appearing. Everything is a clean install on a Gigabyte H310M motherboard/G5400 CPU/8GB RAM/500GB drive.

Any suggestions?


Post Reply