PicoScope5000aExampleBlockMSO.vi - Program runs and then stops with no error code

Post your LabVIEW discussions here
Post Reply
seamot
Newbie
Posts: 0
Joined: Wed Sep 18, 2019 4:07 pm

PicoScope5000aExampleBlockMSO.vi - Program runs and then stops with no error code

Post by seamot » Thu Sep 19, 2019 4:54 pm

Hi,

I am using a PicoScope 5242B. I want to get it running on Labview (2018 version) so I thought this example program (Title) would be a good place to start. I believe I have the ports and USB power configured properly, since the error messages (5003 and 5282) no longer appear when I press run.

When I run the program, it starts with a 'PicoScopeR' loading screen. When it fully loads, the program stops automatically. No error code appears. I want it to run continuously and display the signal, so I'm not sure what I'm doing wrong.

The test signal I'm transmitting is 350Hz sinewave@1V.

P.s. I am able to confirm this signal is received by viewing it on PicoScope 6. I exit PicoScope 6 before running the Labview program.

Thank you for reading, any help appreciated

AndrewA
PICO STAFF
PICO STAFF
Posts: 252
Joined: Tue Oct 21, 2014 3:07 pm

Re: PicoScope5000aExampleBlockMSO.vi - Program runs and then stops with no error code

Post by AndrewA » Fri Sep 20, 2019 1:54 pm

Hi, Could you please email support@picotech.com
And supply following details-
Is this the 32-bit or 64-bit version of LabVIEW? And are you using the 32 or 64-bit version of the code?
What version of the SDK do you have installed?
Are you using the default settings on the front panel? Or have you changed these.
What version of windows are you running?
Regards Andrew
Technical Specialist

Post Reply