Search found 3 matches

by MarBrunero
Thu Jul 11, 2019 3:09 pm
Forum: LabVIEW
Topic: Pico 5243D - Sync scope acquisition with AWG signal output
Replies: 5
Views: 1618

Re: Pico 5243D - Sync scope acquisition with AWG signal output

Thank you Andrew. The provided code works and I was able to use the same settings in my application. Unfortunately, I have to acquire up to 200k different acquisitions (2ch, up to 10kS per channel) and, if Rapid Block Bulk cannot be used, the required time is too long. My understanding is that Rapid...
by MarBrunero
Tue Apr 23, 2019 9:35 am
Forum: LabVIEW
Topic: Pico 5243D - Sync scope acquisition with AWG signal output
Replies: 5
Views: 1618

Re: Pico 5243D - Sync scope acquisition with AWG signal output

Thank you for your reply Andrew. Finally I had time to try to implement your solution for the software trigger, unfortunately without success. Here I attach my LabView diagram and front panel. The AWG output of the picoscope is directly connected to the CHA input. I can acquire a waveform but consec...
by MarBrunero
Tue Jan 29, 2019 4:55 pm
Forum: LabVIEW
Topic: Pico 5243D - Sync scope acquisition with AWG signal output
Replies: 5
Views: 1618

Pico 5243D - Sync scope acquisition with AWG signal output

Hi, I would like to start a single acquisition of a finite number of samples at the same time of the generation of a single short pulse, using the arbitrary AWG, and repeat these two steps (pulse and acquisition) at the end of the previous acquisition, with the shortest delay possibile. Ideally I wo...